Cilio CLASSIC VESUVIO Manual De Instrucciones página 10

Before the first use
· Please read through the operating instructions and safety advice carefully first.
· Remove all packaging material and dispose of it properly.
· Rinse the interior of the kettle with warm water. Wipe the outside with a soft cloth, slightly moistened if needed.
Thoroughly dry the kettle off afterwards.
Caution: Do not use any caustic liquids or abrasive cleaning agents.
· Unwind the cable completely and insert the plug into a suitable socket.
· Fill the kettle with cold water up to the MAX - marking, close the lid completely and boil the water. Pour
this water away and repeat this procedure 2 – 3 times.
· The water kettle is ready for use now.
Use
· Place the base of the water kettle on a suitable surface (not on a metal surface; not on fabrics etc.)
· Open the lid by pressing the button at the handle.
· Make sure that the removable limescale filter is installed properly.
· Pour the desired amount of water (between MIN and MAX) and close the lid until it clicks into place.
Hint: For hygienic reasons always use fresh water.
· Place the kettle on the base plate, just now plug the power cord into a suitable socket and switch it on.
The control lamp lights up.
· As soon as the water boils, the water kettle will switch off automatically.
· By pressing the ON/OFF button you can stop the boiling process.
· After use, disconnect the appliance from the power supply.
· When pouring the water, keep the lid closed. Risk of scalding! Please touch the kettle by the handle only.
· Attention: If you put too little water in (below the MIN marking), the service life of the heating coil can be
shortened. If you put too much water in (above the MAX marking), the water can boil over and
cause scalding.
10