Descargar Imprimir esta página

BABYTREND Smart STEPS WK07 A Serie Manual De Instrucciones página 6

Idiomas disponibles

ASSEMBLY

Attaching the seat fabric

One hand should be pulling down the fabric, while the other hand

presses the plastic board inside the fabric downward, until it SNAPS into

position (Fig. 2a). Repeat this action for every hole.

NOTE: Push the pins from the top of the opening all the way down to

the bottom (Fig 2b).

Fig. 2a

Insert the pins on the back of the seat, into

the holes by pushing downwards until it

clicks (Fig. 2c).

NOTE: Apply pressure to press the top flat

surface of the pin all the way down into the

hole. Repeat this action for all holes.

Fig. 2c

Fig. 2b

Wheels

Place walker on a solid flat

surface with bottom of base

facing upward. Insert the 2

front wheels, 6 stoppers, and 2

rear wheels as shown (Fig. 3).

NOTE: Ensure to apply enough

pressure when inserting the

stoppers so that they push

in lower than the level of all

the wheels. Please check that

wheels are locked into place

before proceeding.

ASSEMBLY

Fig. 3