afx light CLUB-710-IP Manual De Uso página 5

IR REMOTE CONTROLLER
Please operate the remote control within a distance of 6m and 30° between the remote and the
appliance. Aim the remote at the sensor. Remove all obstacles between the remote and the sensor.
The remote control might not work properly if the sensor is exposed to strong sunshine.
If the remote control doesn't work properly, please check the batteries.
INSTALLING THE BATTERIES IN THE REMOTE CONTROL
• Place the remote face down on a flat surface.
• Push the compartment cover into the direction of the arrow.
• Slide the battery compartment open.
• Remove the old battery and install the new one (CR2025) with the plus (+) symbol facing up.
• Gently slide the battery compartment closed. It locks automatically.
RECOMMENDATIONS FOR BATTERIES
This symbol indicates that used batteries should not be disposed of with household waste but deposed correctly in accordance with
your local regulations..
Batteries shall not be exposed to excessive heat such as sunshine, fire or the like.
When the internal batteries are not to be used, remove them to avoid damage caused by battery leakage or corrosion.
ATTENTION: Danger of explosion if battery is incorrectly placed. Only replace by the same or equivalent type.
WARNING :Do not swallow the battery. Danger of chemical burns. Keep new and old batteries out of the reach of children.
If the battery compartment doesn't close properly, stop using the product and keep it out of the reach of children.
If you are in doubt whether the batteries have been swallowed or introduced into any other part of the body, contact immediately a doctor.
REMOTE CONTROL
NOTE: PLEASE SET THE UNIT TO MODE -> ADDR, OTHERWISE THE
REMOTE CONTROL WILL NOT WORK
1. BRIGHTNESS & SPEED adjustment: Press
brightness and speed in programme mode
2. ON/OFF of the LEDs.
3. SELECT BASIC COLOR: Red, Green, Blue or White (R+G+B+W)
4. COLOUR BUTTONS: For constant lighting of all LEDs in one colour,
press the corresponding button.
5. SELECTING AN INTERNAL PROGRAMME:
Flash: Colour switch
Strobe: Colour strobe
Fade: Colour fade
Smooth: Colour switch and strobe
CLEANING AND USING FREQUENCY OF PRODUCT
Please make sure that the light is power off before dismantling or maintaining, it's very important
to keep the light clean. Frequent cleaning will ensure maximum brightness output, but also prolong
the life time. It's suggested to use the high quality, professional glass detergent and soft cloth to
clean the light. It's not allowed to use alcohol or chemical solvent. The inner part of the light should
be cleaned by vacuum cleaner at least once a year. When the light doesn't work, please check if the
fuse is burnt out or not. If it is, the same fuse should be replaced, find out the faulty and restart the
light. But please note the repair must be handled by professional.
or to set the
www.afx-light.com
5 EN