BenQ ScreenBar AR17 Guia Del Usuario página 3

Package Contents
Check the packaging for the following items. If any is missing or damaged, please contact the place
of purchase immediately.
• ScreenBar lamp x 1
The illustrations in this guide are for your reference only and may look different from the
appearance of the actual product.
For Your Safety
• Use only the supplied USB power cable and connect only to USB port power (5V DC, 1A).
Otherwise the lamp will fail to work normally or result in a fire hazard.
• In order to prevent any damages to the lamp, do not hang or place any objects on the lamp.
• Route the USB power cable so as to avoid it from being pinched by items placed upon it or
against it.
• If the lamp will not be used for a long period of time, unplug it from the USB port.
• The light source contained in this luminaire can't be replaced.
CAUTION
Installation
1. As shown in [Figure
2. Rest the clip on top of your monitor [Figures
the clip closely against the monitor frame so there is no visible gap in between [Figure
The applicable range of the monitor frame thickness is 1cm - 3cm.
3. Connect the Micro-USB/Type-C connector of the supplied USB power cable to the Micro-
USB/Type-C port on the lamp [Figure
computer [Figure
USB port.
• Do not use a USB extension cable, or a USB cable other than the one supplied. Otherwise the
lamp will not function properly.
• It is recommended that the lamp's power be supplied by the USB port of your computer. If a
portable power bank or AC power adapter is to be used as the power source for the lamp, the
power output shall meet the requirement (output voltage: 5V, output current: 1A or above) in
order for the lamp to function normally.
• If the Auto Dimmer Mode indicator flashes, make sure you are using the USB cable that is
provided and no USB extension cable is being used.
Using the Lamp
Turning on/off the Lamp and Entering Auto Dimmer Mode
• In case of the following situations, unplug the lamp from the USB port
immediately and contact the authorized service center or a qualified service
person for inspection or repair:
- When the outer casing of the lamp is broken
- When there are strange odors coming from the lamp
- When the LED light source flickers
- When the insulation of the lamp's wiring is damaged or frayed, and the metal
strings inside can be seen
• Do not use the lamp in a humid environment (like in a bathroom or outdoors).
Otherwise the components inside may short-circuit and result in accidents.
• This lamp is designed for indoor use only. Do not use it outdoors.
• Never disassemble the lamp or remove any components from it, as doing so
may result in accidents and will void the product warranty.
], insert the ScreenBar lamp into the clip.
A
]. The lamp will automatically turn ON upon receiving power from the
C 2
Turning on/off the Lamp
To turn on the lamp, touch the power button
turn off the lamp, touch the power button
• Clip x 1 • USB power cable x 1
,
B 1 B 2
], and the USB connector to the USB port of your
C 1
]. It is recommended that you fit
on the lamp. To
again.
English
].
B 3
1