Publicidad
Idiomas disponibles
Idiomas disponibles
Operation
1 Thread lid (10) tightly onto reservoir (12)
(→ Fig. IPB 2, page 10 and Fig. IPB 3,
page 10).
2 Connect fluid dispensing hose (14) or
accessory to quick-connect coupler (4).
NOTE
Verify quick-connect coupler sleeve
snaps to lock connection.
3 Set inlet air supply between 90-120 psi
(6-8 bar).
4 Attach air supply to swivel coupler (7).
To dispense fluid
1 Set slide valve (5) to pressure setting
(→ Fig. 2, page 5; Fig. IPB 2, page 10
and Fig. IPB 3, page 10).
2 Pull top lever (6) back to build pressure in
reservoir (12) and dispense fluid.
3 To stop dispensing fluid, close shut-off
valve on fluid dispensing hose (14) and
push top lever (6) to center position.
4 Bleed off pressure by tilting pressure relief
knob (8) or setting the slide valve (5) to the
vacuum position.
To evacuate fluid
1 Set slide valve (5) to vacuum setting
(→ Fig. 3, page 5; Fig. IPB 2, page 10
and Fig. IPB 3, page 10).
2 Push top lever (6) forward to vacuum and
pull fluid into reservoir (12).
3 To stop, close shut-off valve on fluid dis-
pensing hose (14) and pull top lever (6) to
center position.
4 Release vacuum pressure by tilting pres-
sure relief knob (8).
NOTE
Air supply is not necessary to evacuate
fluids once vacuum is generated. Reser-
voir can remain under vacuum for a
period of time even after air supply is
removed if slide valve (5) is moved to
pressure setting before top lever (6) is
moved to center.
4
NOTE
Built-in pressure relief valve (8) is
designed to open and maintain
maximum pressure between
20 and 25 psi (1.4 and 1.7 bar).
Fluid will continue to flow as long as
pressure/vacuum remains in reservoir.
NOTE
Shut-off valve installed in fluid
dispensing hose (14) may be left open or
closed. When left open, fluid will flow
when top lever (6) is operated. If closed,
pressure/vacuum will build in reservoir.
NOTE
Depending on fluid type and future
intended use, remaining fluid may be
stored in reservoir.
NOTE
Fluid may be left in reservoir.
If fluid is not stored in reservoir, clean
using denatured alcohol or common
household cleaner, and store empty.
Do not use petroleum based solvents for
cleaning unit.
Publicidad
