Publicidad
Idiomas disponibles
Idiomas disponibles
WARNING:
When servicing, use only identical replacement parts.
Use of any other parts could create a hazard or cause
product damage.
GENERAL MAINTENANCE
Avoid using solvents when cleaning plastic parts. Most
plastics are susceptible to damage from various types of
commercial solvents and may be damaged by their use. Use
clean cloths to remove dirt, dust, oil, grease, etc.
REQUIRED DAILY CHECKLIST
„ Remove the battery pack from the tool and remove all
fasteners.
„ Check all screws, nuts, bolts, and pins on the tool. If any
of these are loose, they must be tightened with the ap-
propriate size wrench.
„ Press the workpiece contact against a workpiece to
ensure that it moves smoothly.
„ With the workpiece contact depressed, pull the trigger.
The trigger should move smoothly, without binding.
„ Select the full sequential actuation mode ( ).
„ While the tool is not loaded, insert the battery into the tool.
„ Begin inspection:
• Press the grip switch to activate the nailer.
• Without pulling the trigger, press the workpiece contact
against a workpiece several times. The tool must not
actuate.
• With the workpiece contact not engaged on the
workpiece, point the tool down and away and pull the
trigger several times. Hold the trigger in this position for
a minimum of 5 seconds The tool must not actuate.
• Load fasteners, then press the workpiece contact firmly
against the workpiece and pull the trigger. The tool must
actuate.
• With the workpiece contact still depressed, release the
trigger. The driver must return to its up position.
„ Remove the battery pack and remove all fasteners.
„ Select the contact actuation mode
„ Place the battery pack in the tool.
„ Begin inspection:
• With the workpiece contact not engaged on the
workpiece, point the tool down and away. Pull the trig-
ger. The tool must not actuate.
• Load fasteners, then fully depress the trigger and push
the workpiece contact against a workpiece. The tool
must actuate.
„ Remove the battery pack and remove all fasteners.
MAINTENANCE
.
(
)
11 — English
„ If the tool successfully meets all the requirements in this
checklist, it is ready for use. Set the trigger on the tool
to operate in the manner that best fits your application.
„ Set the depth of drive according to the Depth-of-drive
Adjustment section in this manual.
„ Place the battery pack in the tool and load the proper
fasteners for the desired application. Repeat this checklist
before using the tool each day, or if the tool is dropped
or damaged in any way.
REFILLING THE AIR PRESSURE TANK
See Figure 15, page 15.
After the intial use, you may notice a decrease in performance.
Refilling the air pressure tank to 125 psi can help restore the
unit's perfomance.
„ Remove the battery pack and all nails from the tool.
„ Remove the plastic cover from the bottom of the tool with
the included hex wrench.
„ Twist slightly and remove the plastic cap from the air fill
valve.
„ Connect an air compressor to the valve and pressurize the
tank to a maximum of 125 psi. Allow the tool to recharge
for approximately 30 seconds.
NOTE: It is normal to hear a hissing sound while the tank
is being refilled. Do not overfill. Always check the pressure
before use. If overfilling occurs, a safety overflow valve will
open to allow the excessive pressure to escape. Once the
pressure has decreased, the valve will close automatically.
WARNING:
Never pressurize tank to more than 125 psi. Failure to
heed this warning can result in serious personal injury.
„ Disconnect the air compressor and replace the plastic
cap and cover before use.
„ Reattach the plastic cover to the bottom of the tool with
the included hex wrench.
Publicidad
