4. Preparations
4.1 Prepare the Remote Control
The provided Remote Control allows the unit to
be operated from a distance.
Even if the Remote Control is operated within
•
the e ective range 19.7 feet (6m), remote
control operation may be disrupted if there
are any obstacles between the unit and the
remote control.
If the Remote Control is operated near other
•
products which generate infrared rays, or if
other remote control devices using infrared
rays are used near the unit, it may operate
incorrectly. Conversely, the other products
may operate incorrectly.
4.2 Replace the Remote Control Battery
1
Press and slide the back
cover to open the battery
compartment of the
remote control.
Insert two AAA size
2
batteries . Make sure the
(+) and (–) ends of the
batteries match
the (+) and (–) ends
indicated in the battery
compartment.
3
Close the battery
compartment cover.
Precautions Concerning Batteries
•
Be sure to insert the batteries with correct
⊕
positive "
" and negative " " polarities.
•
Use batteries of the same type. Never use
•
Either rechargeable or non-rechargeable
batteries can be used. Refer to the
precautions on their labels.
•
the battery cover and the battery.
•
Do not drop the remote control.
•
Do not allow anything to impact the remote
control.
•
Do not spill water or any liquid on the remote
control.
•
Do not place the remote control on a wet
object.
•
Do not place the remote control under direct
sunlight or near sources of excessive heat.
•
Remove the battery from the remote control
when not in use for a long period of time, as
corrosion or battery leakage may occur and
result in physical injury, and/or property
10
•
Do not use any batteries other than those
•
Do not mix new batteries with old ones.
•
Never recharge a battery unless it is
4.3 Placement and Mounting
Placement
A
If your TV is placed on a table, you can place
the unit on the table directly in front of the
TV stand, centered with the TV screen.
B
If your TV is attached to a wall, you can mount the
unit on the wall directly below the TV screen.
Note: The unit should be placed to avoid covering the
signal receiver of the TV or the remote of TV can not work.
A
B