EDM Product 31855 Manual De Instrucciones página 10

solar panel. Make sure the joint is fully connected to ensure the
waterproof effect of the whole (as shown in the drawing). The
ES
projector end of the conventional configuration power cord is 50cm,
and the PV solar panel end is 250cm.
CONTROL REMOTO
PT
EN
1
5
FR
3
7
8
10
1. Light On Button: Press this button to turn the light on.
2. Light Off Button: Press this button to turn off the light.
3. Brightness Enhancement Button: Press this button to make the
light brighter
4. Dimmer Button: Press this button to dim the light.
5. Full Power Button: Press this button, the light will turn on at full
power.
6. Half Bright Button: Press this button to turn the light on at half full
power
7. Auto Mode Button: Press this button to activate auto power-on
mode. The projector starts with 100% brightness for 1h, then goes to 70%
brightness for 3h and finally 30% brightness which lasts until dawn.
8. 3H Mode Button: Press this button to balance the brightness of the
light with what is needed intelligently. Please note that the projector will be
on for 3 hours continuously.
9. 5H Mode Button: Press this button to balance the brightness of the
Instruction manual
2
ON OFF
4
M
6
AUTO
9
3H 5H
8H
light with what is needed intelligently. Please note that the projector will be
on for 5 hours continuously.
10. 8H Mode Button: Press this button to balance the brightness of the
light with what is needed intelligently. Please note that the projector will be
on for 8 hours continuously.
MAINTENANCE AND CLEANING
▶ Clean the solar panel regularly to maintain good charging and light
transmission to the projector. This cleaning must be done with a dry
cloth. Never use liquids.
▶Avoid storing and using the projector in corrosive environments
or environments that contain harmful substances such as sulfur,
halide, and phthalate.
10
ref. 31855