POWERCOLOR Red Devil Guía De Instalación Rápida página 6

Addressable RGB (ARGB) LED Cable Connection
• Connect the ARGB LED cable to the ARGB LED Headers between
PowerColor graphics card and your motherboard, the PowerColor LED light
can be controlled by PowerColor Devil Zone software or synchronized via
motherboard software.
* The factory default setting is controlled by PowerColor Devil Zone, if you want to sync with
motherboard software, please disable GPU control on Devil Zone.
• You can also connect another ARGB device to the male connector for syncing
with motherboard ARGB control.
Connect to motherboard header
Connect to PowerColor
graphic card RGB header
* The ARGB LED Header supports ARGB LED cable, with a maximum power rating of 3A (5V)
and total length within 2 meters.
Notices:
- Do not install an RGB LED cable in the ARGB LED Header; otherwise the hardware
and cable may be damaged.
- Only use the ARGB LED cable to connect on both motherboard and PowerColor
graphics card.
- PowerColor graphics card is compatible with motherboards which have headers for
ARGB LED cables. The headers should have the 3-pin configuration. For further
information concerning compatibility, refer to the manual of your mainboard, or visit the
manufacturer's website.
- To avoid damaging any hardware, please make sure the system is turned off and the
power cord is unplugged before connecting or removing the ARGB LED cable.
(Optional) Connect to other components such as
chassis or chassis cooling fans
6