LG LW8022ERSM Manual Del Propietário página 12

Preparation of the Chassis
1
Insert the top and bottom rails of the curtain
panels into the upper and lower panel guides.
Fasten the curtain panels to the unit with 8
type A screws. Fasten screws behind the
curtain panel.
Upper Guide Upper Guide
Left Curtain Left Curtain
Panel Panel
Screws Screws
(Type A) (Type A)
Bottom Guide Bottom Guide
NOTE
• Use a long screwdriver to make installing the
screws easier.
2
Cut the window sash seals to the proper
length. Peel off the backing and attach the
adhesive-backed foam to the underside of the
window sash and bottom of window frame.
3
Open the window and draw a center line on
the center of the inner sill. Then mark lines 8"
to the left and right of the center line.
Inner Sill Inner Sill
Room Side Room Side
8"
12
Right Right
Curtain Curtain
Panel Panel
Screws Screws
(Type A) (Type A)
Foam-PE Foam-PE
(Adhesive backed) (Adhesive backed)
Center Line Center Line
8"
4
Install the L bracket behind the inner window
sill as shown. Use the 2 type A screws
provided.
Inner Sill Inner Sill
Outer Sill Outer Sill
L Bracket L Bracket
NOTE
• The bracket helps to hold unit securely in place.
Be sure to place bracket edge flush against
back of inner sill.
Unit Installation
CAUTION
• During the following step, hold unit firmly until
window sash is lowered to top channel behind
side panel frames. Personal injury or property
damage may result if unit falls from window.
1
Set the air conditioner in the window so that
is centered. Place the air conditioner so that
front edge of the bottom guide is against the
back edge of the sill.
Bring the window down so that the front edge
of the upper guide is in front of the window.
Make sure that air conditioner is level or tilting
slightly to the outside.
Window Frame Window Frame
Upper Guide Upper Guide
Screws Screws
(Type A) (Type A)
Center Line Center Line
Seal Seal
About 1/4" About 1/4"
Bottom Guide Bottom Guide
L Bracket L Bracket
EN