Publicidad
Idiomas disponibles
Idiomas disponibles
STEP 3 Adjust the leveling feet
STEP 4 Connect the water hose
Untitled-11 25
Untitled-11 25
1. Gently slide the washer into position.
Excessive force may damage the
leveling feet.
2. Using a wrench, turn the leveling feet
clockwise or counterclockwise to adjust
the height until the washer is level.
3. Using a flathead screwdriver, tighten
the locking nuts (A) .
NOTE
Use the open-end of the supplied wrench
to adjust the leveling feet.
CAUTION
• Make sure to use new water hoses and
that rubber gaskets (B) are inside the
couplings (A) at both ends of the hoses.
Water hoses without the gaskets may
leak.
• Allow 5 in. (127 mm) of space between
the back of the washer and the wall to
prevent water hoses from being kinked.
B
Kinked hoses may cause water leaks.
• If there is a water leak, stop using the
washer and contact a local Samsung
service center. A water leak may cause
A
electric shock.
• Do not stretch the water hoses by force.
If a hose is too short, replace the hose
with a longer hose.
English 25
2020-04-02
2020-04-02
4:58:39
4:58:39
Publicidad
