Fracarro SIG7100 Instrucciones De Uso página 17

Perform the following operations for a correct installation and configuration of the SIG7100 module:
1. Install the module in the sub-rack (SIG7901 or SIG790) as showed previously
. Connect the SAT antenna cable to the SAT IN coaxial connector;
3. Connect the 75 Ohm isolated load to the coaxial output connector;
4. Insert the CAM module in the Common Interface slot (refer to the CAM INSERTION PROCEDURE chapter);
5. Connect the main power supply to the sub-rack;
6. Wait for the module initialization (the green LED is fixed ON and the red LED is in flashing status);
7. Connect the TPE to the interconnection module of the sub-rack and carry out the preliminary programming
operations that are described in the next paragraphs (see the paragraph PROGRAMMING INSTRUCTIONS).
Green LED
OFF
Flashing
ON
ON
ON
ON
ON if a fault is present
Flashing OFF if it is locked
Flashing if it is not locked
The CAM device (not supplied) can be inserted/removed in the Common Interface slot located in the bottom part
of the receiver also with the SIG7100 turned on.
ATTENTION: when you use the CAM (not supplied), take note of the maximum operating temperature
declared by the manufacturer.
WARNING: When showing the channel on the RCA outputs, or in the output of the back panel, the message
"encrypted program" may be displayed, even if you have the decodification rights. Wait a few seconds and the
display and decoding will continue automatically (the video display wait is directly dependent from the CAM).
WARNING: a few functions of the CAM are accessible only after they are enabled. For further information see the
CAM menu (menu: COMMON INTERFACE – MENU CI).
4. OPERATION INSTRUCTIONS
LEDs status table:
Red LED
OFF
ON
Flashing
Flashing The receiver is supplied properly, but it is not locked
OFF
The receiver is supplied properly but there is an internal
ON
4.1 CAM INSERTION PROCEDURE
17
Meaning
Receiver off
Receiver boot
The receiver is initializing itself
The receiver is supplied properly and is locked
fault
Receiver interrogation