Publicidad
Idiomas disponibles
Idiomas disponibles
Installing the Light Kit
CAUTION
To Reduce The Risk Of Electric
Shock, Disconnect The Electrical Supply
Circuit To The Fan Before Installing Light
Kit.
REMEMBER The fan blades must already
be attached to the fan.
Your fan and light kit though pre-wired have
been disassembled at the factory to ease in
shipping.
Please follow these steps to
complete the installation of your fan and
light. TO REDUCE THE RISK OF FIRE
D O N O T E X C E E D M A X I M U M
WATTAGE RATING.
1.Remove 1 screw and loosen 2 screws on the
mounting plate. Secure the compartment box
cover to the mounting plate by tightening
screws previously removed and loosened.
(Figure 18)
2.Remove 3 screws on compartment box cover.
(Figure 19)
3. While holding the light kit assembly under
your fan, snap together the wire connection
plug. (Figure 19)
4. Carefully push all wires back into the
compartment box,
then install the light kit
assembly onto the compartment box cover with
the 3 screws previously removed. Be sure to
tighten all screws. (Figure 19)
5. To install light kit glass shade, remove
the socket ring on the light kit and install
the glass shade to the light kit. Secure by
tightening the socket ring previously .
removed. (Figure 20)
6. Install three E27*13W bulbs. (included)
7. Restore power and your light kit is ready
for operations.
NOTE:
MAKE SURE TO LEAVE ENOUGH SPACE
BETWEEN THE FAN PULL CHAIN AND
THE BULBS TO THE CHAIN DOESN 'T RUB
AGAINST ANY OF THE BULBS. LIGHT
BULBS HAVE NO WARRANTY, CAN BE
P U R C H A S E D A T L O C A L H O M E
IMPROVEMENT STORE OR FROM OUR
SERVICE CENTER.
mounting plate
Compartment box cover
screw
Figure 18
Housing
Screw
Compartment
box
Light kit
Socket ring
Figure 19
Housing
Figure 20
Compartment
box cover
Wire connection
plug
8
Publicidad
