YATO YT-82909 Manual De Instrucciones página 8

EN
GENERAL SAFETY CONDITIONS
NOTE! Get acquainted with all the instructions below. Failure to observe them may lead to an electric shock, fi re or injuries. The notion of electric tool used in the
instructions applies to all the tools which are powered with electric current, both wire tools and wireless ones.
OBSERVE THE FOLLOWING INSTRUCTIONS
Caution when using a power tool.
Before inserting a battery pack make sure that the switch stays in "OFF" position. Inserting a battery pack into a power tool, when the switch is in "ON"
position may cause accidents.
Use only chargers recommended by the manufacturer. Using a charger designed for only one type of battery pack, to charge other types of battery pack may
be a cause of fi re.
Use power tools only with battery pack specifi ed by the manufacturer. Use of other battery pack may be a cause of injuries or fi re.
When the battery pack is not used, it should be stored away from metal objects, such as paper clips, coins, nails, bolts or other small metal elements,
that may short the terminals. Shorting terminals of a battery may cause burns or fi re.
In adverse conditions, a liquid may escape from a battery; avoid any contact with this liquid. In case of accidental contact with a liquid, rinse with water.
If a liquid gets into your eyes, please seek medical advice. A liquid escaping from a battery may cause irritations or burns.
PREPARATION FOR WORK
ATTENTION! All the operations mentioned in this point must be realised with the power supply off .
- the battery must be disconnected from the tool!
Safety recommendations for battery loading
Attention! Before loading may start make sure the body of the charger, the cable and the plug are not broken or damaged. It is prohibited to use a damaged
loading dock and charger! For the purpose of loading batteries only the charging dock and the charger provided may be used. Using another charger may be a
cause of fi re or damage the tool. Batteries may be charged only in a dry room, protected from unauthorised persons, particularly children. Do not use the charging
dock and the charger without permanent supervision of an adult! If it is necessary to leave the room where loading is taking place, it is required to disconnect
the charger from the mains, removing the charger from the mains socket. In case when smoke comes out of the charger, or a strange smell is emitted, etc., it is
required to immediately remove the plug of the charger from the mains socket!
The drill and automatic return screwdriver is provided with an unloaded battery, so before work may commence, it is required to charge it following the procedure
below, using the charger and charging dock provided. Li-ION batteries do not show the so called "memory eff ect", so it is allowed to charge them at any moment.
O P E R A T I N G I N S T R U C T I O N
8