Publicidad
Idiomas disponibles
Idiomas disponibles
NOTE
The maximum reach can be achieved by fitting the
extension tube between the handle pole and the
hedge trimmer head.
WARNING
Periodically check the connections to ensure that they
are tightened securely.
8.2
REMOVE THE HEDGE TRIMMER
HEAD
Figure 4
1. Rest the machine on the ground.
2. Loosen the couplers.
3. Take off the trimmer head / handle pole.
8.3
INSTALL THE BATTERY PACK
Figure 5
WARNING
•
If the battery pack or charger is damaged, replace
the battery pack or the charger.
•
Stop the machine and wait until the engine stops
before you install or remove the battery pack.
•
Read, know, and do the instructions in the battery
and charger manual.
1. Align the lift ribs on the battery pack with the
grooves in the battery compartment.
2. Push the battery pack into the battery compartment
until the battery pack locks into place.
3. When you hear a click, the battery pack is installed.
8.4
REMOVE THE BATTERY PACK
Figure 5
1. Push and hold the battery release button.
2. Remove the battery pack from the machine.
9
OPERATION
•
Do not put your fingers into the notches or in
position where they can get cut.
•
Do not touch the blade unless you remove the
battery pack.
•
Do not use the machine if the blade is damaged or
bent.
•
Remove all objects such as cords, lights, wire, or
string which can become entangled in the cutting
blade and create a risk of personal injury.
English
If the blade jams on an electrical cord or line, DO NOT
TOUCH THE BLADE! IT CAN BE LIVE AND
DANGEROUS. Do the steps below:
1. Hold the insulated rear handle or put the machine
down and away from you.
2. Disconnect the electrically service to the damaged
line or cord before you try to free the blade.
9.1
START THE MACHINE
Figure 6.
Before operation,
1. Attach the shoulder strap to the carrying ring on
the rear handle.
2. Put on the shoulder strap.
3. Adjust the length of the strap so that the carabiner
is about a hand's width below your right hip.
1. Pull the small safety lock button upward.
2. Press the safety lock button.
3. Press the trigger while you hold the safety lock
button.
4. Release the safety lock button.
Hold the machine with two hands during operation.
9.2
STOP THE MACHINE
Figure 6.
1. Release the trigger to stop the machine.
9.3
ADJUST THE TRIMMER HEAD
ANGLE
Figure 7
The trimmer head pivots 135° and can be locked into 7
positions within that range.
1. Pull the pivot button and move the head forward or
backward to your desired position.
2. Release the pivot button.
The trimmer head should lock securely in place.
7
WARNING
NOTE
WARNING
WARNING
EN
Publicidad
