BTI PROFILINE BH 11-80 ME Manual Original página 23

Product Features
The numbering of the product features refers to the
illustration of the machine on the graphics page.
1 Dust protection cap
2 Locking sleeve
3 Release button for mode selector switch
4 Mode selector switch
5 On/Off switch
6 Thumbwheel for speed preselection/impact fre-
quency preselection
7 Service indicator
8 Auxiliary handle
Accessories shown or described are not part of the
standard delivery scope of the product. A complete
overview of accessories can be found in our accessories
program.
Technical Data
Rotary Hammer
Art. No.
Rated power input
Rated speed
Impact rate
Impact energy per stroke
Chisel positions
Tool holder
Lubrication
Max. drilling dia.
– Concrete (with twist
drill)
– Concrete (with break-
through drill bit)
– Brickwork (with core
bit)
Weight according to
EPTA-Procedure 01/2003
Protection class
Noise/Vibration Information
Measured sound values determined according to
EN 60745.
Typically the A-weighted noise levels of the product
are: Sound pressure level 91 dB(A); Sound power
level 102 dB(A). Uncertainty K =3 dB.
Wear hearing protection!
Vibration total values (triax vector sum) determined
according to EN 60745:
Hammer drilling into concrete: Vibration emission value
2
a =21 m/s , Uncertainty K=1.5 m/s
h
Chiselling: Vibration emission value a
Uncertainty K=1.5 m/s
1 619 929 861 • 3.11.09
BH 11-80 ME
9016307
W
-1
min 120 – 250
-1
min 1100 – 2250
J
SDS-max
Central permanent
lubrication
mm
mm
mm
kg
2
,
=16 m/s
h
2
.
The vibration emission level given in this information
sheet has been measured in accordance with a stand-
ardised test given in EN 60745 and may be used to
compare one tool with another. It may be used for a pre-
liminary assessment of exposure.
The declared vibration emission level represents the
main applications of the tool. However if the tool is
used for different applications, with different accesso-
ries or poorly maintained, the vibration emission may
differ. This may significantly increase the exposure level
over the total working period.
An estimation of the level of exposure to vibration
should also take into account the times when the tool
is switched off or when it is running but not actually
doing the job. This may significantly reduce the expo-
sure level over the total working period.
Identify additional safety measures to protect the oper-
ator from the effects of vibration such as: maintain the
tool and the accessories, keep the hands warm, organ-
isation of work patterns.
Declaration of Conformity
We declare under our sole responsibility that the prod-
uct described under "Technical Data" is in conformity
with the following standards or standardization docu-
1500
ments: EN 60745 according to the provisions of the
directives
28 Dec 2009), 2006/42/EC (from 29 Dec 2009).
5 – 18
Technical file at:
12
BTI Befestigungstechnik GmbH
D-74653 Ingelfingen
Jürgen Dietz
General Manager
52
80
150
11.1
BTI Befestigungstechnik GmbH
74653 Ingelfingen
/II
Assembly
Before any work on the machine itself, pull
the mains plug.
Auxiliary Handle
Operate your machine only with the auxiliary
handle 8.
The auxiliary handle 8 can be set to any position for a
secure and low-fatigue working posture.
2
,
2004/108/EC, 98/37/EC
i. V. Günter Hub
Purchasing Manager
(until
English | 23