Publicidad
Idiomas disponibles
Idiomas disponibles
To access the Menu during normal operation, press and hold the ■ MENU button for 5 seconds . The button label will
blink with the text "MENU" while the button is being held to indicate that the Menu is being requested . When the label
stops blinking, release the button and the Menu will be displayed . Alternatively, the
both be held down at the same time for 15 seconds and this will access the Menu . NOTE: The OEM Configuration option
will only be displayed when the Menu is accessed by holding the
is used to access the menu, the OEM Configuration option will not be shown .
Throughout all of the setup and options menus, the
menu choice, or to increase or decrease a highlighted value . The three buttons below the screen will have on-screen la-
bels to identify their function . For example, pressing the ■ ENTER button will enter the highlighted menu screen . Press-
ing the = DONE button will return to the previous menu . These labels will change depending on which menu screen is
active .
7.1 Display
Menu location: Setup Menu ■ Display
The Display Menu contains options to adjust the brightness of the screen, as well as the option to display or hide the "%
open" value that overlays the valve position bar graph . The menu options are as follows:
• Auto Dim
• LCD Brightness
• Numeric Position on Graph
Auto Dim: The LCD screen can automatically dim depending on the light conditions . To enable Auto Dim,
follow these steps:
1 . Navigate to the Display Menu
2 . Use the
RED or
GREEN button to toggle Auto Dim on or off
3 . Press the ■ SET button to save the value .
Note: If Auto Dim is turned on, the LCD brightness option (see below) is grayed out and cannot be adjusted .
LCD Brightness: The LCD brightness can be manually set to a desired percentage if the Auto Dim option is turned off .
To adjust, follow these steps:
1 . Navigate to the display menu
2 . Make sure Auto Dim is set to "OFF" (see above)
3 . Press the ■ NEXT button once so the LCD brightness value is highlighted
RED or
4 . Use the
5 . Press the ■ SET button to save the value .
Numeric Position on Graph: The % value that is displayed within the valve position bar graph can be turned on or off . To
turn on or off, follow these steps:
1 . Navigate to the display menu
2 . Press the ■ NEXT button twice so the Numeric Position on Graph value is highlighted
3 . Use the
RED or
4 . Press the ■ SET button to save the value .
RED and
GREEN button to adjust the LCD brightness to the desired value
GREEN button to turn on or off
RED and
GREEN buttons . If the ■ MENU button
GREEN buttons can be used to move to a different
Page 12
RED and
GREEN buttons can
Publicidad
