Publicidad
Idiomas disponibles
Idiomas disponibles
Downloaded by: pd-oliana on 07-03-2023 10:29 CET
1. Do not use naked flame, and do not smoke.
2. Do not operate any electrical switch.
3. Do not use telephone or mobile phone.
4. Open the doors and windows.
5. Close all valves on the appliances that utilize gas and the gas counters.
6. Call fire brigade from a telephone outside the home.
7. Check all hoses and their connections against leaks. If you still smell gas, leave the house and warn your
neighbours.
8. Do not enter into the house until authorities clarify it is safe.
Intended Use
1. This product is designed for home use. Commercial use of the appliance is not permitted.
2. This appliance may only be used for cooking purposes. It shall not be used for other purposes like heating a room.
3. This appliance shall not be used to heat plates under the grill, drying clothes or towels by hanging them on
the handle or for heating purposes.
4. The manufacturer assumes no responsibility for any damage due to misuse or mishandling.
5. Oven part of the unit may be used for thawing, roasting, frying and grilling food.
6. Operational life of the product you have purchased is 10 years. This is the period for which the spare parts
required for the operation of this product as defined is provided by the manufacturer.
ELECTRICAL CONNECTION
1. Your oven requires 16 Ampere fuse according to the appliance's power. If necessary, installation by a quali-
fied electrician is recommended.
2. Your oven is adjusted in compliance with 220-240V AC 50/60Hz.electric supply. If the mains are different
from this specified value, contact your authorized service.
3. Electrical connection of the oven should only be made by the sockets with earth system installed in com-
pliance with the regulations. If there is no proper socket with earth system in the place where the oven will be
placed, immediately contact a qualfied electrician. Manufacturer shall never be responsible from the damages
that will arise because of the sockets connected to the appliance with no earth system. If the ends of the elec-
trical connection cable are open, according to the appliance type, make a proper switch installed in the mains
by which all ends can be disconnected in case of connecting / disconnecting from / to the mains.
4. If your electric supply cable gets defective, it should definitely be
qualfied electricians in order to avoid from the dangers.
5. Electrical cable should not touch the hot parts of the appliance.
6. Please operate your oven in dry atmosphere.
ELECTRICAL CONNECTION SCHEME
GAS CONNECTION
WARNING: Before starting any work related with gas installation, turn off gas supply. Risk of explosion.
Please operate your oven in dry atmosphere.
1. Fit the clamp to the hose. Push one of the hose until it goes to the end of the pipe.
2. For the sealing control; ensure that the buttons in the control panel are closed, but the gas cylinder is open.
Apply some soap bubbles to the connection. If there is gas leakage, there will be foaming in the soaped area.
3. The oven should be using a well ventilation place and should be
4. Re-inspect the gas connection.
5. When placing your oven to its location, ensure that it is at the counter level. Bring it to the counter level by
adjusting the feet if necessary.
6. Do not make gas hose and electrical cable of your oven go through theheated areas, especially through the rear side
of the oven. Do not move gas connected oven. Since the forcing shall loosen the hose, gas leakage may occur.
7. Please use flexible hose for gas connection.
Main Gas Pipe
Gasket
Hose Inlet Connector
Metal Clamp
Lpg Connection Hose
FOR LPG CONNECTION:
For LPG (cylinder) connection, affix metal clamp on the hose coming from LPG
cylinder. Affix an edge of the hose on hose inlet connector behind the appliance
by pushing to end through heating the hose in boiled water. Afterward, bring the
clamp towards end section of the hose and tighten it with screwdriver. The gasket
and hose inlet connector required for connection is as the picture shown below.
NOTE: The regulator to be affixed on LPG cylinder should have 300 mmSS feature.
(For example: lamp switch or doorbell)
replaced by the authorized service or
install on flat ground.
Publicidad
