TFA 30.3074.10 Instrucciones De Uso página 13

TFA_No. 30.3074_Anl_04_23
Wireless Thermometer
• Remove the batteries if the device will not be used for an
extended period of time. Avoid contact with skin, eyes and
mucous membranes when handling leaking batteries. In case of
contact, immediately rinse the affected areas with water and
consult a doctor.
CAUTION
• Unauthorised repairs, alterations or changes to the product are
prohibited.
• Do not expose the device to extreme temperatures, vibrations
or shocks.
• Clean the device with a soft damp cloth. Do not use solvents or
scouring agents.
• The base station is suitable for indoor use only. Protect it from
moisture!
• The transmitter is splashproof, but not watertight (see "Location
and mounting").
4. Elements
Base station (Receiver)
A: LCD display (Fig. 1):
A 1: Time with seconds
A 2: DCF reception symbol
A 3: Time zone
A 4: Automatic reset (AUTO)
A 5: Indoor temperature
A 6: Minimum values (MIN)
A 7: Maximum values (MAX)
A 8: Humidity
A 9: Outdoor temperature
A 10: Symbol for alternating channels
A 11: Channel number
A 12: Transmitter reception symbol
A 13: Battery symbol transmitter
A 14: Comfort level (smiley)
A 15: Battery symbol for the base station
A 16: Date
B: Buttons (Fig. 1):
B 1: SET button
19.04.2023 16:18 Uhr
– 24 –
Seite 13
Wireless Thermometer
B 2: CHANNEL button
B 3: –/MIN button
B 4: MAX/+ button
C: Housing (Fig. 2):
C 1: Wall mounting hole
C 2: Battery compartment
C 3: Table stand (removable)
Transmitter
D: Display (Fig. 3):
D 1: Channel 1,2,3
D 2: Transmission signal
D 3: Battery symbol for the transmitter
D 4: Outdoor temperature
E: Housing (Fig. 3):
E 1: Battery compartment
E 2: Support for wall mounting or table standing
E 3: Indentations for the holder for wall mounting
F: Buttons in the battery compartment (Fig. 3):
F 1: TX button
F 2: 1 2 3 switch for channel selection
5. Getting started
5.1 Insert the batteries
• Place the base station and the transmitter on a table at a dis-
tance of about 1.5 meters from each other. Avoid being close to
possible sources of interference such as electronic devices and
radio equipment.
• Open the battery compartment of the transmitter and insert two
new AA 1.5 V batteries, polarity as illustrated. All LCD segments
will be displayed for a short moment.
• The display shows the temperature. The switch is set to chan-
nel 1.
• Close the battery compartment.
• Open the battery compartment of the base station.
– 25 –