Allmatic KALOS XL 1200 Instrucciones Para La Instalación página 10

BASE PLATE INSTALLATION
Respecting the overall size, fix to ground the base plate (Fig. 5) through 4 sturdy
screw-anchors or drown it into the concrete (Fig. 6).
Plan for one or more sheathing for the passage of the power lines.
Note: It is necessary to know the rack dimensions to can calculate exactly the
counter-plate positioning.
MOTOR AND RACK FITTING
The rack shall be fitted over the motor support, at a certain distance from It.
Its height can be adjusted thanks to the holes In the rack.
The height adjusting is necessary to prevent the gate leaning on the driving gear
(Fig. 7, 8, 9).
To fix the rack on the gate, drill some Ø 5 mm holes and thread them using a
M6 screw tap.
The driving gear needs a clearance of about 0,5 / 1 mm from the rack.
To fix the gearmotor to the base plate, insert and tighten the two socket head
screws into the specific housing (Fig. 10).
Place the motor in parallel to the gate and with the gear below the rack as shown
in Fig. 11.
Note: It is important to lock the two socket head screws forcefully, making sure,
that the gearmotor is steady on the ground, during the whole gate running.
NO
10/28
OK
FIG. 11
ITA ENG
FIG. 5
FIG. 7
Measurements in mm
110
FIG. 10
FRA ESP DEU
10 mm
h
135
6-1624804 rev.4 03/05/2017
FIG. 6
FIG. 8
FIG. 9