Publicidad
Idiomas disponibles
Idiomas disponibles
Tool Specifications
Jigsaw
Order number
Rated power
Output power
Stroke rate at no-load
Stroke
Stroke rate preselection
Cutting capacity:
– in wood, max.
– in aluminium, max.
– in non-alloy steel, max. [mm]
– in stainless steel alloy,
max.
Bevel cuts (left/right)
Weight
without cable, approx.
Protection class
Machine Elements
1 Rotatable top handle with pushbutton
2 Stroke rate preselection thumbwheel
3 Allen key
4 On/Off switch
5 Switch for sawdust blowing device
6 Lever for adjustment of pendulum action
7 Stroke rod
8 Guide roller
9 Saw blade*
10 Contact protector
11 Base plate
12 Scale
13 Screw
14 Angle gauge**
15 Thread
16 Positioning pin/marking
17 Splinter guard
18 Circle Cutter/Parallel Guide*
* Not all of the accessories illustrated or described are
included as standard delivery.
** Commercially available (not included in the delivered
items)
BTI-ST 85
015864
[W]
580
[W]
350
[spm]
500 – 3100
[mm]
26
•
[mm]
85
[mm]
20
10
[mm]
3
[°]
0 – 45
[kg]
2.4
/ II
English - 1
Noise/Vibration Information
Measured values determined according to
EN 50 144.
Typically the A-weighted sound pressure level of
the product is 83 dB (A).
The noise level when working can exceed
85 dB (A).
Wear hearing protection!
The typical hand/arm vibration is below 2.5 m/s
Intended Use
The machine is intended for making separating
cuts and cut-outs in wood, plastic, metal, ceramic
plates and rubber while resting firmly on the
workpiece. It is suitable for straight and curved
cuts with mitre angles to 45°. The saw blade rec-
ommendations are to be observed.
For Your Safety
Working safely with this ma-
chine is possible only when the
operating and safety information
are read completely and the in-
structions contained therein are
strictly followed. Before using
for the first time, ask for a practi-
cal demonstration.
Wear safety goggles.
When working, never guide a hand or fingers
in front of the saw blade.
If the mains cable is damaged or cut through
while working, do not touch the cable but im-
mediately pull the mains plug. Never use the
machine with a damaged cable.
Connect machines that are used in the open
via a residual current device (RCD) with an ac-
tuating current of 30 mA maximum. Use only
extension cables that are approved for outdoor
use.
Insert the mains plug only when the machine is
switched off.
Always direct the cable to the rear away from
the machine.
Do not work with materials containing asbes-
tos.
Apply the machine to the workpiece only when
switched on.
The cutting path must be free of obstacles both
above and below.
2
.
Publicidad
