Publicidad
Idiomas disponibles
Idiomas disponibles
MAINTENANCE & CARE
16
16A
16E
16D
16C
16 FLUSHING & AERATOR CLEANING
After installation is complete, remove Aerator Housing (16A). Turn Valves (16B) on
and allow both hot and cold water to run for at least one minute each. While water is
running, check for leaks. To clean the aerator, disassemble Aerator Housing (16A) by
separating the Aerator Shell (16C), Basket (16D), and Washer (16E). Once parts have
been cleaned, reassemble by reversing steps.
17
17 HANDLE REMOVAL
Turn off water before proceeding! With Valves in "Closed" position, unscrew Fastener
(17A) and remove Handle (17B) from Valve Stem (17C).
18
18 VALVE CARTRIDGE REMOVAL
Turn off water supplies and relieve pressure before working on your faucet (see
step 2). Remove Handles (see step 17), Valve Flange (18A) and Plastic Nut (18B)
unscrew Retainer Nut (18C) by turning it counter-clockwise and lift out Cartridge
Assembly (18D) and inspect. Replace parts as necessary.
16B
17A
17B
17C
18B
18A
18C
18D
ENGLISH
CAUTION: Maintenance
DISASSEMBLY
1.
Replacement parts may be available at the store where you purchased
your faucet.
2.
When replacement parts are not available, please write or call Price Pfister
Consumer Service.
3.
Always turn off water and relieve pressure before working on your
faucet.
NOTE: Trim Care
Cleaning Instructions:
For all Handles and decorative finishes, use only a soft damp cloth
to clean and shine. Use of polish, detergents, abrasive cleaners,
organic solvents or acid may cause damage. Use of other than
a soft damp cloth will nullify our warranty!
Special Trim:
Trim products which contain Porcelain or other similar substance
are not acceptable for public areas or Commercial use. Installation
of Said Trim is at Users Risk!
1–800–PFAUCET (1–800–732–8238)
For Toll-Free Pfaucet information call
1–800–PFAUCET (1–800–732–8238)
or visit www.pricepfister.com
• Installation Support
• Care and Warranty Information
5
Publicidad
