Kohler K-1703 Guia Del Usuario página 4

FCC Compliance (cont.)
interference that may cause undesired operation.
Warning (Part 15.21)
Changes or modifications not expressly approved by the party
responsible for compliance could void the user's authority to operate
the equipment.
Programming the Remote Control
NOTE: Programming of the remote control is required. If you
replace your remote control or replace the pump control, it is
necessary to program the remote control.
Turn the whirlpool power on.
Turn off all modes of operation. Wait approximately one minute
until the keypad darkens completely.
On the user keypad, press the up arrow, down arrow and the
heater button simultaneously. The bottom LED on the keypad's
indicator bar will begin flashing.
While the LED is flashing, press the heater button on the keypad.
A light sequence will illuminate up and down the indicator bar.
While the indicator bar light sequence is active, press any button
on the remote control. The program will download and the user
keypad will darken. The user keypad will now respond only to
this remote control.
Cleaning Your Remote Control
For best results, keep the following in mind when caring for your
KOHLER product:
• Use a mild detergent such as liquid dishwashing soap and warm
water for cleaning. Do not use abrasive cleaners that may scratch
or dull the surface.
• Carefully read the cleaner product label to ensure the cleaner is
safe for use on the material.
• Always test your cleaning solution on an inconspicuous area
before applying to the entire surface.
• Do not allow cleaners to sit or soak on the surface.
1021550-5-D 4 Kohler Co.