Snapper 7900925 Manual Del Operador página 23

Problem
Mower will not
mulch grass
Uneven cut
Mower will not self propel
Cause
1. Wet grass.
2. Excessively high grass.
3. Dull blade.
1. Dull blade.
1. Belt not installed properly.
2. Debris clogging drive operation.
3. Damaged or worn belt.
4. Drive control out of adjustment.
Remedy
1. Do not mow when grass is wet; wait until
later to cut.
2. Mow once at a high cutting height, then
mow again at desired height or make a
narrower cutting path.
3. Sharpen or replace blade.
1. Sharpen or replace blade.
1. Check belt for proper pulley installation and
movement.
2. Stop engine, disconnect spark plug boot,
and clean out debris.
3. Inspect and replace belt.
4. Adjust drive control. (See Assembly & Set-up
section).
S 8 — t
ection roubleShooting
23