Toshiba 43QA4C Serie Guia De Inicio Rapido página 3

1
Inserting the batteries into the remote
Remove the screw that secures the battery compartment cover on the back side of the remote control first. Lift
the cover gently. Insert two 1.5V - size AAA batteries. Make sure the (+) and (-) signs match (observe correct
polarity). Do not mix old and new batteries. Replace only with same or equivalent type. Place the cover back
on. Then screw the cover back on again.
2
Connections
Antenna
Connect the antenna cable/s to your TV.
Rear side of the TV
1
LNB
1. Satellite
Left side of the TV
ANT
2. Aerial or cable
Power
After unpacking, allow the TV set to reach the ambient room temperature before you
connect the set to the mains. Plug the power cable to the mains socket outlet.
IMPORTANT: The TV set is designed to operate on a 220-240V AC, 50 Hz supply.
3
Switching on the TV
In order to turn the TV on from standby mode:
• Press the Standby button on the remote control
• Press the control button on the TV
2
English - 1 -
External Devices
PLEASE ENSURE BOTH UNITS ARE
SWITCHED OFF BEFORE CONNECTING
Use the proper cable to connect two units together.
To select the desired input source, press the Source
button on the remote control.
HDMI connection
rear side or rear-left
side of TV