REV 318A0080 Instalación página 6

Make sure the clamp is inserted
5
all the way up into the rail and
clamp teeth are aligned to rail
slots to ensure a secure grip.
Place the 2nd clamp near the center of the rail.
7
See steps 5 and 6 to ensure the clamp goes on
correctly. (8' beds- evenly space 2 clamps
between the ends).
9
Set the cover in the folded position on the rails towards the front
of cab.
The small panel faces forward, toward the cab and folds down over
the slotted brackets. The front panel must sit just inside the bulkhead
rail with the seal resting on top of the rail. Fold the panel down and
align it so it is setting squarely on the rails and align the mounting
holes with the silver slotted brackets on the rails.
Rev Industries HFC
6
Apply downward pressure to the rail when tightening the
clamp to ensure the rail sets flush and seals properly.
8
10 ft/lb
Place the rear clamp approximately 6 inches (150mm) from
the tailgate. Using a 9/16 wrench, tighten all of the clamps
until snug. Then torque an additional 1/2 turn (approximately
10 ft/lb). Repeat steps 3-8 on the opposite side.
Before mounting the cover on truck, using a screwdriver
install the two buckle ends into pre-drilled holes on the
front header with the provided machine screws and
threaded posts. DO NOT use a screw gun, securely
tighten by hand only.
Part# 318A0080 Rev. 7.23.2020