Publicidad
Idiomas disponibles
Idiomas disponibles
Note 2: Cross-connect the transmit channel at each end to the receive channel at the
SC Connector
RX
RX
TX
TX
Cable Wiring(SC to SC)
Warming: The Fiber interface is Class 1 Laser/LED product. Do not look into the
Laser/LED beam.
Device Management
JetNet 5628G/5828G Rack Mount Managed Ethernet Switch provides both in-band and
the attached console cable. Or you can remotely manage the switch via network. You can
choose Telnet/SSH, Web/HTTPS management.
1. Preparation for console management: Attach the RS-232 DB9 connector to your PC's
COM port. Connect the RJ-45 connector to the console port of the JetNet 5628G/5828G.
1.1 Go to Start -> Program -> Accessories -> Communication -> Hyper Terminal
1.2 Give a name to the new console connection.
1.3 Choose the COM name, and select the correct serial settings. The serial settings of
the JetNet 5628G are as below: Baud Rate: 9600 / Parity: None / Data Bit: 8 / Stop Bit: 1
1.4 After connected, you can see Switch login request. Type the username and password
then you can login. The default username is "admin", password is "admin".
2. Preparation for Web management: Before you attempt to use the embedded web interface
to manage switch operation, verify that your JetNet 5628G/5828G is properly installed on
your network and that every PC on this network can access the switch via the web browser.
SFP Connector (100Base-FX/1000Base-x)
TX
TX
RX
RX
A
B
Cable Wiring (LC to LC)
Publicidad
