Discs - Teac SL-D920 Manual Del Usuario

Discs that can be played on this unit
< Commercial audio CD's bearing the "Compact Disc
Digital Audio" logo
< Properly finalized CD-R/CD-RW discs
Note:
< Depending on the quality of the disc and/or the
condition of the recording, some CD-R discs might not
be playable.
< Copy-protected discs and other discs that do not
conform to the CD standard might not play back
correctly in this player.
If you use such discs in this unit, TEAC Corporation
and its subsidiaries cannot be responsible for any
consequences or guarantee the quality of reproduction.
If you experience problems with such nonstandard
discs, you should contact the producers of the disc.
< Always load the disc with the label side up. (Only one
side of Compact Discs can be played and recorded.)
< To remove a disc from its storage case, press down on
the centre of the case and lift the disc out, holding it
carefully by the edges.
How to remove a disc
< Should a disc become dirty, wipe the surface radially
with a soft, dry cloth. Never clean a disc using a circular
motion.
6

Discs

How to hold a disc
< Never use such chemicals as record sprays, antistatic
sprays or fluids, benzene or thinner to clean the discs.
Such chemicals will do irreparable damage to the disc's
plastic surface.
< Discs should be returned to their cases after use to
avoid dust and scratches that could cause the laser
pickup to "skip".
< Do not expose discs to direct sunlight or high humidity
and temperature for extended periods. Long exposure
to high temperatures will warp a disc.
< CD-R/CD-RW discs are more sensitive to the effects
of heat and ultraviolet rays than ordinary CDs. It is
important that they are stored in a location where
direct sunlight does not shine on them and that is away
from heat sources such as radiators and heat-generating
electrical devices.
< Printable CD-R/CD-RW discs are not recommended
because the label side might be sticky and could
damage the unit.
< Do not stick papers or protective sheets on the discs
and do not use any protective coating spray.
< Use a soft, oil-based, felt-tipped pen when writing on
the label side. Never use a ballpoint or hard-tipped pen,
because this could damage the recorded side.
< Never use a stabilizer. Using commercially-available CD
stabilizers with this unit will damage the mechanisms
and cause them to malfunction.
< Do not use irregularly-shaped CDs (octagonal, heart-
shaped, etc.). They could damage the unit.
< If you are in any doubt as to the care and handling of a
CD-R/CD-RW disc, read the precautions supplied with
the disc, or contact the disc manufacturer directly.