4
Assemble the mesh.
Secure the mesh to the heating body
using 3pcs screw M5X10.
Material used
Screw
M5 x 10
(Qty 3)
6
Assemble the reflector.
Screw 3pcs stud to the top of mesh,using
3pcs washer Ø6 to the bottom and 3pcs
washer Ø6 to the top.
Put the reflector on the stud and secure
them using 3pcs wing nut and 3pcs washer.
Material used
Wing nut
Washer
(Qty 3)
(Qty 9)
Philips screwdriver
(Qty 1)
Stud
(Qty 3)
28
Assemble the upper protective mesh to
5
the heating body directly
7 Connect the gas hose and regulator after that
Connect the regulator to the gas cylinder.
WARNING! Ensure the hose does not
contact any high temperature surfaces,or
it may melt and leack causing a fire.
After
the
cylinder
heater,secure the cyliinder with block melt tightly.
is
placed
inside
the