Ryobi RY48140 Guía De Armado página 7

INSTALL THE DRIVE LEVERS
See Figure 3.
 Remove the hex head bolts from the drive lever mounting
bracket.
 Align the holes on the drive lever with the holes on the
drive lever mounting bracket as shown.
 Reinstall the bolts and tighten securely.
 Repeat to install second drive lever.
NOTE: Make sure to use the same holes for mounting the
drive lever on each side. The levers must be even once
installed.
DRIVE LEVER
MOUNTING
BRACKET
CHECK TIRE PRESSURE
Check the air pressure in all tires before use. Improper air
pressure will affect handling, steering response, traction,
tire life, level cutting, and operator comfort. Be sure tires
are inflated to the pressure shown below.
NOTE: Tire pressure should only be measured or
adjusted when tires are cold.
Recommended
Pressure
WARNING:
Check the tire pressure carefully while inflating. Too much
air in the tire could cause the tire to burst, causing seri-
ous personal injury.
ASSEMBLY
DRIVE
LEVER
HEX HEAD
BOLTS
Fig. 3
FINAL PREPARATION
Front Rear
19 PSI 18 PSI
7 — English
INSTALL THE TOWING PLATE
See Figure 4.
 Align the holes in the towing plate with the holes in the
rear crossmember.
 Install two hex head bolts and tighten securely.
TOWING
VERIFY MOWER CONDITION
Inspect the entire product for damaged, missing, or loose
parts such as screws, nuts, bolts, caps, etc. Tighten securely
all fasteners and caps and do not operate this product until
any missing or damaged parts are replaced.
PLATE
HEX HEAD
BOLTS
Fig. 4