Publicidad
1
2
3
4
84
2.#1
SOURCE
BAND
PROG
BAND
PROG
CD Shuttle Operation
Multi-Changer Selection
2.#
Alpine's Ai-NET system will support up to 6 CD
Shuttles. When operating two or more
changers, the KCA-400C (Multi-Changer
Switching Device) must be used. If you use 1
Switching device, you can connect up to 4 CD
Shuttles. If you use 2 Switching devices, you
can connect up to 6 CD Shuttles.
Press the SOURCE button on the CDA-W550
to activate the CD Shuttle mode.
Alternatively, press the SOURCE button on the
Remote Control (RUE-4185) to activate the CD
Shuttle mode. Proceed to Step 3 below to
select the desired CD Shuttle.
Press the BAND button on the CDA-W550 or
the RUE-4185 to activate the CD Shuttle
Selection mode.
The CD Shuttle Selection mode remains active
for 3 seconds after Step 2 is performed. Press
the BAND button until the desired CD Shuttle
indicator appears on the display.
Note: If the selected CD Shuttle is not con-
nected, the display will show "NO
CHGRX".
Alternatively press the BAND button on the
Remote control until the desired changer
indicator appears on the display.
To operate the selected changer, see "CD
Operation" section.
English
1
Publicidad
