Glacier bay 1002-774-598 Guía De Uso Y Cuidado página 6

Installation
1
Installing the 1/2" pipe nipple
□
Apply generous amount of
both threaded ends of the 1/2" pipe nipple,
whichever is needed for the application.
NOTE: This product includes two pipe nipples, but only one
will be used during installation. When installed, the nipple
should extend no more than 1/2" (12mm) past the finished
wall, and no less than 1/4" (7mm) past the finished wall. One
of the two included nipples should work for your application,
but if neither size works for your application, you can find a
variety of pipe nipple sizes at your local Home Depot store.
3-Option 1
Suction Installation
□
Turn the seat (F1) counterclockwise to remove it
from the slide bar
□
Push the suction assembly (I) and clamping
plate (H), by order as shown below, tight to the wall.
NOTE: Clean the wall before installation and make sure the
wall's surface is smooth (like glass wall or glaze tile).
23.34"
25.74"
thread sealant tape(A) to
B or C
A
3/8±1/8"
(F-shown on #4).
F1
H
I
2
Installing the connector
□
Screw connector (D) in a clockwise motion onto
B or C;
the outlet pipe nipple.
3-Option 2
Tape Installation
□
Turn the seat (F1) counterclockwise to remove it
from the slide bar
□
Put the tape (G) and seat (F1) on the wall by order
as shown below.
NOTE: Make sure the wall is clean and there are no rough
surfaces and gaps on the wall.
25.74"
6
D
(F-shown on
F1
23.34"
G
Hex key
#4).
F1