Descargar Imprimir esta página

Glacier bay 1002-774-598 Guía De Uso Y Cuidado página 7

Publicidad

Idiomas disponibles

Idiomas disponibles

Installation
3-Option 3
Screw Installation
Turn the seat (F1) counterclockwise to remove it from
the slide bar
(F-shown on
Drill two 1/4" (7mm) holes in the wall which line up
with the seat (F1) screw holes. Push and secure
anchors (BB) into these holes.
Put the seat (F1) and the screws (AA), by order as
shown below, and fasten the screws (AA) to secure
the seat tight to the wall.
F1
24.54"
5
Installing the flange
Insert the flange (E) into the slide bar.
E
#4).
F1
AA
BB
4
Installing the slide bar
Insert the pipe (J) into the slide bar (F) as shown
below.
Tighten the set screw (DD) to secure the slide bar.
NOTE: You may need to slightly loosen the set screws before
inserting the connector to avoid damaging the O-rings.
CC
DD
6-Option 1
Suction Installation
□ Push the top side of the slide bar onto the
connector (D), place the bottom part of the slide bar
onto the suction assembly (I) and rotate clockwise to
secure the bottom part tight to the suction assembly (I).
Tighten the set screws (DD) to lock the slide bar to
the connector as below.
NOTE: You may need to slightly loosen the set screws before
inserting the connector to avoid damaging the O-rings.
D
I
7
Please contact 1-855-HD-GLACIER for further assistance.
J
F
CC
DD
HOMEDEPOT.COM

Publicidad

loading

Este manual también es adecuado para:

Hd58101-x5110hHd58101-x5101304778429