Power Supply; Setting The Transmitter - Monacor JTS IN-264TH/5 Manual De Instrucciones

www.cept.org
→ ECC
→ Topics
→ Short Range Devices (SRD) and other R&TTE
sub-classes
→ EFIS and National Frequency Tables

4 Power Supply

For power supply, two 1.5 V batteries of size AA are
required.
G
Only insert two batteries of the same type and
always replace both of them.
G
If the transmitter is not in use for a longer period
of time, always remove the batteries to prevent
damage due to battery leakage.
Do not dispose of used batteries in the
household waste; always take them to a
special waste disposal, e. g. collection
container at your retailer.
1) Unscrew the sleeve (6) on the lower end of the
transmitter.
2) Slide the cover (7) of the battery compartment
(8) downwards and open it.
3) Insert the batteries with the positive and negative
poles as indicated in the battery compartment.
4) Close the cover, press it down on the batteries,
then slide it upwards to lock it.
5) Screw the sleeve on the transmitter again.
5 Operation
1) Before switching on the hand-held transmitter,
set the receiver unit to an interference-free
transmission frequency
of the receiver.
2) To switch on the transmitter, press the button
/ (2). The display (1) shows the group
( , the channel of the group and a battery
... )
symbol indicating the current battery status in
4 levels:
full
Each time you press a button, the display back-
light will be activated for a few seconds (green
in normal mode).
3) Via the REMOSET function, the transmitter is
automatically set to the transmission frequency
of the receiver unit. For correct operation, make
sure that
instruction manual
discharged
– the transmitter is not too far away from the
receiver (maximum range of REMOSET
transmission: 10 m)
– the automatic frequency matching for the
transmitter has been enabled
– the transmitter and the receiver unit have
been set to the same identification number
chapter 5.1.5
– the transmitter is not locked
Check the settings on the transmitter and
correct them, if necessary. Then activate the
REMOSET function on the receiver unit
instruction manual of the receiver. When the
frequency is matched, the display backlight on
the transmitter is blue. The display briefly shows
and the transmitter will be set to the
channel and the channel group of the receiver
unit.
Manual setting of the channel group and the
channel on the transmitter is also possible
chapter 5.1.1.
4) Speak / sing into the microphone. The display of
the receiver unit shows the volume level of the
microphone. To readjust it, change the sensitiv-
ity chapter 5.1.2.
5) To mute the microphone for short interruptions,
press the button
muted, the display backlight is red. In this case,
the backlight is not extinguished automatically
but starts flashing after a few seconds.
To unmute the microphone, press the button
/ once again.
6) The transmitter is provided with a lock function
to prevent accidental change of settings or
switching off chapter 5.1.6.
7) To switch off the transmitter, keep the button
/ (2) pressed until the display shows
Then the transmitter is switched off.

5.1 Setting the transmitter

When the transmitter is not locked, press the button
SET (4) to activate the setting modes one after
another: group (keep button pressed for a while)
→ channel → sensitivity → transmission power
→ automatic frequency matching → identification
number → lock function
To make settings in a setting mode, see the corre-
sponding chapter 5.1.1 to 5.1.6.
To exit a setting mode without changing a setting,
press the button SET repeatedly until the display
briefly shows . The unit will then return to the
normal mode.
chapter 5.1.4
chapter 5.1.6
/ (2). When the sound is
.
9