Poulan Pro 220 LE Manual De Instrucciones página 6

Computed kickback angle (CKA) Table
BAR
MODEL P/N Length
220 LE 530044834 16"
260 LE 530044835 18"
NOTE: If this saw is to be used for commer-
cial logging, a chain brake is required and shall
not be removed or otherwise disabled to com-
ply with Federal OSHA Regulations for Com-
mercial Logging.
SAFETY NOTICE: Exposure to vibrations
through prolonged use of gasoline powered
hand tools could cause bIood vessel or nerve
damage in the fingers, hands, and joints of
people prone to circulation disorders or
abnormal swellings. Prolonged use in cold
weather has been linked to blood vessel
damage in otherwise healthy people. If
symptoms occur such as numbness, pain,
loss of strength, change in skin color or texture,
or loss of feeling in the fingers, hands, or joints,
discontinue the use of this tool and seek
medical attention. An anti-vibration system
does not guarantee the avoidance of these
problems. Users who operate power tools on
a continua] and regular basis must monitor
closely their physical condition and the
condition of this too].
SPECIAL NOTICE: Your saw is equipped
with a temperature limiting muffler and spark
arresting screen which meets the
requirements of California Codes 4442 and
4443. All U.S. forest land and the states of
California, Idaho, Maine, Minnesota, New
Jersey, Oregon, and Washington require by
CHAIN P/N CKAwithout chain brake
952051480 8 °
952051481 6 °
Protective gloves (not provided) should be
worn during assembly.
ATTACHING THE BAR & CHAIN (if not
already attached)
_, WARNING:
If received
assembled,
repeat all steps to ensure your saw is properly
assembled and all fasteners are secure. At-
ways wear gloves when handling the chain.
The chain is sharp and can cut you even when
it is not moving!
1. Loosen and remove the chain brake nuts
and the chain brake from the saw.
2. Remove the plastic shipping spacer (if
present).
Location of shipping spacer
a_ Chain Brak{_e
Oh Nuts
Bar Tool
law that many internal combustion engines
to be equipped with a spark arresting screen.
if you operate a chain saw in a state or Iocale
where such regulations exist, you are legally
responsible for maintaining the operating
condition of these parts. Failure to do so is
a violation of the law. Refer to the SERVlCE
section for maintenance of the spark
arresting screen.
Failure to follow all Safety Rules and Precau-
tions can result in serious injury. If situations
occur which are not covered in this manual,
use care and good judgement. If you need
assistance, contact your authorized service
dealer or call 1-800-554-6723.
STANDARDS: This saw is listed by Under-
writer's Laboratories, Inc., and the Canadian
Standards Association in accordance with:
ANSI B175.1-2000 American National
Standard for Powered Tools - Gasoline
Powered Chain Saw - Safety Requirements
CSA Z62.1-03 Chain Saws - Occupational
Heaith and Safety
CSA Z62.3=96 Chain Saw Kickback Occu-
pational Health and Safety
3. Turn adjusting screw on bar counter-
clockwise to move the tensioning rack as
far as it will go toward the front of the bar.
(_ co_,o _:_ Adjusting
Screw
Tensioning Rac_kk _
4. Slide the bar behind clutch drum until bar
stops against clutch drum sprocket.