Assembly - RIDGID R860430 Manual Del Operador

ASSEMBLY

UNPACKING
This product requires assembly.
 Carefully remove the tool and any accessories from the
box. All items listed in the Includes section must be
included at the time of purchase.
WARNING:
Items in this Assembly section are not assem-
bled to the product by the manufacturer and
require customer installation. Use of a product
that may have been improperly assembled
could result in serious personal injury.
 Inspect the product carefully to make sure no breakage
or damage occurred during shipping.
 Do not discard the packing material until you have care-
fully inspected and satisfactorily operated the product.
 If any parts are damaged or missing, please call
1-866-539-1710 for assistance.
WARNING:
If any parts are damaged or missing do not
operate this product until the parts are replaced.
Use of this product with damaged or missing
parts could result in serious personal injury.
WARNING:
Do not attempt to modify this product or create
accessories not recommended for use with this
blower. Any such alteration or modification is
misuse and could result in a hazardous condi-
tion leading to possible serious personal injury.
WARNING:
To prevent accidental starting that could cause
serious personal injury, always remove the bat-
tery pack from the tool when assembling parts.
ASSEMBLING THE BLOWER TUBE
See Figure 2, page 10.
 With the latch slot facing up, slide the blower tube over
the outlet on the blower housing.
 Press down on the tab on the blower housing outlet.
 Push tube on the blower housing outlet until tab locks
into place through the slot in the blower tube.
 To remove the blower tube, push tab down and slide tube
off.
6 — English