Zbeamz MegaCluster Laser RGB 600mW DMX IRC Manual De Instrucciones página 6

LASER INDICATOR INSTRUCTION
The three RGB buttons on the top of the unit control the colours of the laser output. RGB corresponds with
Red, Green and Blue laser diode respectively.
When a button is pressed and it's corresponding LED is lit, the laser will run that colour. When the button is
pressed again and it's corresponding LED flickers, the colour will run at random. When the button is pressed
yet again and it's corresponding LED is off, the corresponding colour will not output from the laser.
When use button to choose 2 colors or 3 colors, the default is random color change (use the remote controller
to choose fixed color).
REMOTE CONTROLL
Button function:
A. Auto/Sound Mode
B. Blackout / Standby
C. Color setting (RGB)
D. Direction / Gobo (Auto speed ranging from SP1 to SP9)
Note : When the remote control is not working and in a sleeping mode, press the color button to unlock it.
Caution : The max working distance of remote control is 50M. There must be no barrier between the laser and
remote control. Otherwise it would affect the max distance.
If the unit doesn't work with the remote control, complete the following instructions.
Press and hold the MENU and ENTER buttons at the same time, the indicator light at the bottom right of the LED display will
light up, then release both buttons. Next press any button on the wireless remote control to make the connection, the indicator
light at the bottom right of the LED display should flicker four times to indicate that the unit and wireless remote are paired and
can work together.
To stop the unit from working with the supplied remote control, complete the following instructions.
Press and hold the MENU and ENTER buttons at the same time, the indicator light at the bottom right of the LED display will
light up, keep holding both buttons and don't release until the indicator light turns off. When the indicator light turns off, the unit
and the wireless remote are no longer paired and will not work together.
DMX-512 CONNECTION
If you are using a standard DMX controller, you can connect the DMX-output of the controller directly to the DMX-input of the
first fixture in a DMX chain. Connect the output of the first fixture with the input of the next fixture until all fixtures are connected.
If you use a controller with 5-pin DMX connection, you will need to use a 5-pin to 3-pin adapter.
Caution at the last fixture, the DMX cable has to be terminated. Solder a 120 Ohm resistor between signal (-) and
signal (+) into a 3-pin XLR connector and plug this into the DMX output of the last fixture in the chain.
DMX ADDRESS SETTING
When controlling the laser (or lasers) with a DMX controller, every laser must be set with a specific DMX address. You can
choose to set all lasers with the same DMX address or you can set every laser with its own DMX address.
If all lasers are set with the same DMX address, they will receive all same DMX-signal. If operated in this way, all lasers will
operate in the same way, you cannot control each laser separately.
If you set every laser with a different DMX address, they will receive DMX-signal from their own DMX-address. You will now be
able to control each laser individually. The DMX-address that you set for each laser must be determined by the number of
channels. In this situation, the laser use 5 DMX-channels, set the DMX-address of the first laser to 1, the second laser must
then be set to DMX-address 6 (5+1), the third laser must be set to DMX-adress 11 (5+6) etc.
6