Sony XAV-AX5650 Manual De Instrucciones página 15

Using an HDMI device
Installation of an HDMI cable (not supplied) is
required before use.
1
Connect an HDMI cable to the HDMI
terminal at the back panel of the unit.
2
Pass the cable tie  through the cable
holder, then tie the cable tie  around the
HDMI cable.
The HDMI cable is secured to the unit.
*

* HDMI cable (not supplied)
3
Connect the installed HDMI cable to an
HDMI device.
4
Press HOME, then touch [HDMI].
The HDMI device connected will be mirrored to
this unit.
Using the rear view camera
Installation of the rear view camera (not supplied) is
required before use.
The picture from a rear view camera connected to
the CAMERA IN terminal is displayed when:
– the back lamp of your car lights up (or the shift
lever is set to the R (reverse) position).
– you press HOME, then touch [Rear Camera].
Installation
Removing the mounting sleeve
Before installing the unit, remove the mounting
sleeve  from the unit.
1
Insert both release keys  until they click,
and pull down the mounting sleeve , then
pull up the unit to separate.

Face the hook inwards.

Mounting the unit in the dashboard
• Before installing, make sure the catches on both
sides of the mounting sleeve  are bent inwards
3.5 mm ( / in).
5
32
• For Japanese cars, see "Mounting the unit in a
Japanese car" (page 16).
1
Position the mounting sleeve  inside the
dashboard, then bend the claws outward
for a tight fit.

Larger than
Catch
182 mm (7 1 /
Larger than
111 mm (4 / in)
3
8
in)
4
15
GB