Descargar Imprimir esta página

Johnson JINDU529FLEX Manual De Instrucciones página 66

Publicidad

Idiomas disponibles

Idiomas disponibles

If the hob is installed above an oven, the oven has a built-in cooling
fan.
The installation will comply with all clearance requirements and
applicable standards and regulations.
A suitable isolating switch providing full disconnection from the mains
power supply is incorporated in the permanent wiring, mounted and
positioned to comply with the local wiring rules and regulations.
The isolating switch must be of an approved type and provide a 3 mm
air gap contact separation in all poles (or in all active [phase] conductors
if the local wiring rules allow for this variation of the requirements).
The isolating switch will be easily accessible to the customer with the
hob installed.
You consult local building authorities and by-laws if in doubt regarding
installation.
You use heat-resistant and easy-to-clean finishes (such as ceramic
tiles) for the wall surfaces surrounding the hob.
9.3 After installing the hob, make sure that
The power supply cable is not accessible through cupboard doors or
drawers.
There is adequate flow of fresh air from outside the cabinetry to the base
of the hob.
If the hob is installed above a drawer or cupboard space, a thermal
protection barrier is installed below the base of the hob.
The isolating switch is easily accessible by the customer.
9.4 Before locating the fixing brackets
The unit should be placed on a stable, smooth surface (use the packaging).
Do not apply force onto the controls protruding from the hob.
9.5 Adjusting the bracket position
Fix the hob on the work surface by screw 2 brackets on the bottom of
hob(see picture) after installation.
33
V.1

Publicidad

loading