Publicidad
Idiomas disponibles
Idiomas disponibles
contamination always protect against
backflow when connected to a potable
water system.
Water
Source
High Pressure
Hose Hook-up
6.
Connect high pressure hose to
pump outlet.
7.
If applying a chemical or
cleaning solution, see How
To Apply Chemicals/Cleaning
Solvents instructions in this
section.
8.
Turn water source on.
do so could cause damage to the
pump.
9.
Remove all air from the pump
and high pressure hose by
depressing trigger until a steady
stream of water is present.
10. Start engine. See Engine Owners
Manual for correct procedure.
does not start after two pulls,
squeeze trigger of gun to relieve
pump pressure. Pull starter cord
slowly until resistance is felt. Then
pull cord rapidly to avoid kickback
and prevent hand or arm injury.
11. Depress trigger on gun to start
water fl ow.
a stable surface and grip gun/spray
wand fi rmly with both hands. Expect
the gun to kick when triggered.
To reduce the
possibility of
Risk of property
damage. Failure to
Risk of unsafe
operation. If engine
Risk of unsafe
operation. Stand on
12. Release trigger to stop water
fl ow.
engage the trigger lock when gun
is not in use. Failure to do so could
cause accidental spraying.
Trigger Lock Engaged
13. Adjust nozzle spray for the task
being performed. See How To Use
Wand instructions in this section.
SHUTTING DOWN
1.
After each use, if you have applied
chemicals, place chemical hose
into container of clean water and
draw clean water through chemical
injection system to rinse system
thoroughly.
to do so could cause damage to the
pump.
2.
Turn engine off. See Engine
Owner's Manual.
turn the water off with the engine
running.
3.
Turn water source off.
4.
Pull trigger on spray gun to relieve
any water pressure in hose or spray
gun.
5.
See Storage section in this manual
for proper storage procedures.
13 - ENG
Risk of injury from
spray. Always
Risk of property
damage. Failure
Risk of property
damage. NEVER
A16064
Publicidad
