Connection N&C WNU150 Manual De Usuario página 29

Troubleshooting
If a cross icon appears, indicating a failed connection, see the Troubleshooting for suggestions on prob-
lems connecting to a wireless network.
For further information on the screens used in this procedure, see the Profile Setting screens.
Setting Up a Wireless Network
You can use the Ralink Utility to set up an access point (AP) for a wireless network. If your Adapter is
connected to a computer with an Internet connection, any computer or device connected to your wireless
network can also connect to the Internet.
Instructions
Follow these instructions to set up an AP for a wireless network.
1. To begin setting up the AP, set the Ralink Utility to AP Mode. Right-click on the Ralink icon
the task bar in the bottom right hand corner of your screen.
2. In the menu that appears, click "Switch to AP Mode". Wait several seconds for the Utility to ap-
pear in AP Mode.
3. If you have more than one network card, the following popup appears. In 'WAN Adapter Name',
select the card you will use to connect to the Internet (or other network). The adapter name
given here is an example only, the name of your network card may differ.
29
in