Philips AUT3015 Manual Del Usuario página 14

* The actual lifetime of the filter cartridge depends on the local tap water quality
and daily usage. The recommended replacement cycle is an average based on
di erent local tap water quality. If the local tap water quality is below the average,
the actual lifetime of the cartridge would di er from the recommended replacement
cycle. If the filter cartridge is blocked, please replace it.
3. Filter cartridge replacement
a. Turn off the power and water supply before replacing the filter cartridges.
b. Remove the front cover.
c. Turn the filter that needs to be replaced anticlockwise and pull it out.
d. Remove the packaging of the new filter and insert the cartridge in the system.
Turn it clockwise to align the triangle icon on the lter cartridge with the lock icon
on the system.
e. Turn on the water supply and re-connect with power. If the RO lter is replaced,
turn on the RO filtered water lever of the faucet and allow the water to run for
30 minutes. If the CP lter is replaced, turn on the ltered water lever of the faucet
and allow water to run for 10 minutes.
f. Reset the filter lifetime according to chapter V.
Note:
In the process of the filter replacement, if there is water dripping from the filter,
it may set o the leakage detector when you reconnect with power. Make sure the
leakage detector and the floor is wiped dry before you reconnect with power.
VII. Precautions
1. Warning
- This is NOT a water puri er. Always use municipal tap water as the water source.
Do not use water that is microbiologically unsafe or of unknown quality without
adequate disinfection before or after the system.
- This system is not intended for use by persons (including children) with reduced
physical sensory or mental capabilities, or lack of experience and knowledge
unless they have been given supervision or instruction concerning the use of
the appliance by a person responsible for their safety. Children should be
supervised to ensure that they do not play with the system.
12