Hilti NURON DGH 130-22 Manual De Instrucciones Original página 28

▶ Keep batteries away from rain, moisture and liquids. Penetrating moisture can cause short circuits,
electric shock, burns, fire and explosions.
▶ Use only chargers and power tools approved for the specific battery type. Read and follow the relevant
operating instructions.
▶ Do not use or store the battery in explosive environments.
▶ If the battery is too hot to touch, it may be defective. Put the battery in a place where it is clearly visible
and where there is no risk of fire, at an adequate distance from flammable materials. Allow the battery to
cool down. If it is still too hot to touch after an hour, the battery is faulty. Consult Hilti Service or read the
document entitled "Instructions on safety and use for Hilti Li-ion batteries".
Observe the special guidelines applicable to the transport, storage and use of lithium-ion batteries.
→ page 28
Read the instructions on safety and use of Hilti Li-ion batteries that you can access by scanning
the QR code at the end of these operating instructions.
3 Description
3.1 Product overview
3.2 Intended use
The product described is a cordless diamond grinder for dry-grinding, fine-grinding and polishing mineral
materials. Use the diamond grinder only in combination with a dust extractor.
• For this product, use only Hilti Nuron lithium-ion batteries of the B 22 series. For optimum performance,
Hilti recommends the batteries stated in the table at the end of these operating instructions for this
product.
• For these batteries, use only Hilti chargers of the type series stated in the table at the end of these
operating instructions.
22 English
1
Gripping surface
@
Spindle lock button
;
On/off switch
=
Grip
%
Buttons for speed stages
&
Adjusting lever for segment opening
(
Guard
)
Battery release button
+
Battery status indicator
§
Battery
/
Pad holder for finishing pad (DLX only)
:
Finishing pad for finishing (DLX only)
∙
Installation opening
$
Sealing lip
£
Spindle
|
Clamping flange
¡
Diamond cup wheel
Q
Quick-release lock nut
W
Height adjustment of the guard
E
Connector for dust extraction
R
2359096
*2359096*