Main Functions; Measure Distance (Single Measurement) - Hilti PD-I Manual Del Usuario

• The light conditions are unfavorable (bright sunshine).
When measuring with a target plate, add 2 mm (1/16 in) to the measured distance.
6 Operation
6.1 Overview of the functions
Press the button to cycle through the main functions.
The "Measure distance" function is selected by default every time the device is switched on.
You can switch from every main function directly to the "Measure distance" function by pressing the
button.
If a measurement has already been taken, press the
To repeat a function (Area, Volume, Pythagoras or Layout function), press the
regular measurement procedure finishes.
1. Measure distance (single measurement) → page 8.
2. Measure area → page 8.
3. Measure volume → page 9.
4. Pythagoras (2-point) → page 9.
5. Pythagoras (3-point) → page 9.
6. Layout function → page 10.
6.2

Main functions

6.2.1

Measure distance (single measurement)

The laser switches off automatically:
• When a single measurement has been carried out.
• When 90 seconds pass without a measurement being carried out.
• When you switch from a main function directly to the "Measure distance" function.
Short-press the
1. Aim the laser at a target point.
2. Press the
button.
▶ Measurement has been completed.
The following values are shown on the display:
• Previous measurement
• Measured distance
3. For more single measurements, switch the laser on and repeat the procedure.
6.2.2 Measuring area
1. Aim the laser at a target point for the room length.
2. Press the
button.
3. Aim the laser at a target point for the room width.
4. Press the
button.
▶ Measurement has been completed.
The following values are shown on the display:
• Measured lengths
• Calculated result
Press button
8 English
5
button to switch the laser on.
6
and hold it down for 2 seconds to view the room perimeter.
button twice.
2222191
*2222191*
button after the