Care, Transport And Storage; Storage And Drying - Hilti PD-I Manual Del Usuario

Malfunction
240
252
253
255
256
257
trc
8

Care, transport and storage

8.1 Cleaning
▶ Do not touch the lens with the fingers.
▶ Clean the lens by blowing off dust or by wiping with a clean, soft cloth.
▶ Use only pure alcohol or water for cleaning.
▶ Do not dip the laser range meter into water.
8.2 Transport
The batteries must be insulated or removed from the product before it is shipped or sent by mail.
▶ Use the Hilti packaging or packaging of equivalent quality for transporting or shipping your equipment.
8.3

Storage and drying

▶ Do not put the product into storage when wet. Allow it to dry before putting it away.
▶ Observe the temperature limits given in the Technical Data section which are applicable to storage or
transport of the equipment.
▶ Check the accuracy of the equipment before it is used after a long period of storage or transportation.
8.4 Disposal
WARNING
Risk of injury. Hazards presented by improper disposal.
▶ Improper disposal of the equipment may have the following consequences: The burning of plastic
components generates toxic fumes which may present a health hazard. Batteries may explode if
damaged or exposed to very high temperatures, causing poisoning, burns, acid burns or environmental
pollution. Careless disposal may permit unauthorized and improper use of the equipment. This may
result in serious personal injury, injury to third parties and pollution of the environment.
Most of the materials from which Hilti products are manufactured can be recycled. The materials must be
correctly separated before they can be recycled. In many countries, your old tools, machines or appliances
can be returned to Hilti for recycling. Ask Hilti Service or your Hilti representative for further information.
12 English
Possible cause
Fault in data transmission
Product has overheated.
The product is too cold.
Incoming signal too weak, mea-
surement takes too long.
Incoming signal too high
Target surface too bright
Distance was less than the mini-
mum measurable distance.
Distance was greater than the
maximum measurable distance.
Action to be taken
▶ Connect the product and try
again.
▶ Allow the product to cool down.
▶ Comply with the specified oper-
ating and storage temperatures.
▶ Warm up to the product.
▶ Comply with the specified oper-
ating and storage temperatures.
▶ Change the target surface (e.g.
white paper).
▶ Change the target surface (e.g.
white paper).
▶ Darken the target surface.
▶ Measure within the laser range
meter's stated measuring range
(minimum 0.05 m).
▶ Measure within the laser range
meter's stated measuring range
(maximum 100 m).
2222191
*2222191*