Therabody RecoveryAir PRO Instrucciones De Uso página 5

Using the Optional Waist and Leg Extenders
You may use the Optional Expanders to increase the width or circumference of the waist and legs. (see Figure 2).
1. Completely open the zippers located at the sides of the pants.
2. Then, zip the respective expanders (1 for each side, Right or Left) all the way from the feet to the waist/torso.
3. Once you feel the pants are adjusted to a comfortable fit, you can begin your massage.
Operating the RecoveryAir PRO Pump
1. Securely insert the garment hose bundle connectors, with the logo facing up, into the air sockets on the pump.
2. Select a pressure of up to 50 mmHg for use with your RecoveryAir PRO Compression Pants.
Note: Filling the garment may take longer on the first inflation. The garment should not fit too tightly. You should be able to insert three fingers into the garment when
it is fully closed before inflation.
Caution
• Do not use the RecoveryAir PRO Compression Pants at pressures over 50 mmHg. Using the
RecoveryAir PRO Compression Pants at pressure above 50 mmHg may cause discomfort and
may reduce the effect of treatment.
• Do not stand or walk while wearing the garment. Put on the garment while in a seated position
and remove it before rising from the treatment position.
• RecoveryAir PRO Compression Pants are not intended for use in a standing or seated position.
Use in a reclined or supine (lying face up) position only.
• Do not inflate the pants without wearing it over the intended body area ("on empty") or with
open zippers. Doing so can damage the garment.
• Do not apply excessive force to the pant straps. Do not use the straps for any purpose other
than intended by Therabody. Use of excessive force and/or misuse shall void the warranty.
• Stop treatment and consult your licensed medical practitioner if you experience the onset of
pain, bruising or irritation during or after treatment.
• Do not use the RecoveryAir PRO Compression Pants if you are pregnant.
Warranty
For full warranty information, please visit www.therabody.com/warranty. To request a copy of
the warranty by mail, you may send a request to the following address:
Therabody - Warranty
Attn: Customer Service,
6100 Wilshire Blvd., Suite 200
Los Angeles, CA 90048
Please note, this is not a return address or a retail location. No products or packages will be
accepted at this location.
Figure 2
EN
2