Installation
Instructions
Questions? Call 800.GE.CARES (800.432.2737) or Visit our Website at: ge.com
WARNING:
personal injury or property damage.
• Check with your state and/or local public works department for plumbing codes. You must
follow their guides as you install the Water Filtration system.
NOTE: Failure to comply with these installation instructions will void the product warranty, and
the installer will be responsible for any service, repair or damages caused thereby.
TOOLS AND MATERIALS
REQUIRED FOR INSTALLATION
• Electric drill and 1-1/4" Drill Bit (type as
required) if mounting is needed for faucet
• Two (2) Adjustable Wrenches
• 1/16" Drill Bit (optional for pilot holes)
• Tape Measure
• Phillips and Flat Blade Screwdrivers
• Utility Knife
• If your main water line is a rigid pipe,
you will require a compression fitting
and possibly other plumbing hardware
to complete the installation.
CAUTION:
sink, consult a qualified plumber or installer
for drilling procedures. Special drill bits may
be needed for porcelain or stainless steel.
CONTENTS INCLUDED
WITH PRODUCT
• Reverse Osmosis Assembly and Tubing
• Product Literature (Owner's Manual and
Installation Instructions)
• Performance Data Sheet
• Feed Water Adapter and Supply Valve
• Faucet Assembly with Electronic Base
Monitor and Tubing
• Storage Tank
• Drain Line Adapter
Reverse Osmosis Filtration System
Read entire manual. Failure to follow all guides and rules could cause
To avoid damaging the
Models PNRQ20FBL, PNRQ20FWW,
PNRQ20FBB and PNRQ20FCC
BEFORE BEGINNING INSTALLATION
Read these instructions completely
and carefully.
IMPORTANT
•
instructions for local inspector's use.
IMPORTANT
•
governing codes and ordinances.
• Note to Installer – Be sure to leave these
instructions with the Consumer.
• Note to Consumer – Keep these
instructions for future reference.
• Proper installation is the responsibility
of the installer.
• Product failure due to improper installation
is not covered under the Warranty.
• A shutoff valve must be available or added
near the installation point.
6
— Save these
— Observe all