Descargar Imprimir esta página

MTD 25A-262J793 Manual Del Operador página 10

Motor de 159 cc & 196 cc con eje vertical y válvulas en cabeza

Publicidad

Idiomas disponibles

Idiomas disponibles

Shut off the engine before performing any maintenance. To prevent accidental start-up, remove safety key (if equipped),
disconnect the spark plug wire and ground against the engine.
GENERAL RECOMMENDATIONS
If engine must be tipped to transport equipment, inspect or remove grass, keep spark plug side of engine up. Transporting or tipping
engine spark plug down may cause smoking, hard starting, spark plug fouling, or oil saturation of air cleaner.
Periodic inspection and adjustment of the engine is essential to maintaining engine performance and service life.
Required service intervals and maintenance are described in the table below. Follow the hourly or calendar intervals as listed. More
frequent service is required when operating in adverse conditions.
If the engine has been running, the muffler will be very hot. Allow engine and muffler to cool before performing any
maintenance.
MAINTENANCE SCHEDULE
Service
Check Engine Oil Level
Change Engine Oil *
Check Air Cleaner
Service Air Cleaner **
Check Spark Plug
Replace Spark Plug
Clean Engine Shroud
Clean around muffler
Replace Fuel Filter
* Every season or 25 hours if operating under heavy load or high ambient temperature.
** Service more frequently when used in dusty areas.
OIL SERVICE
• Check oil level regularly.
• Be sure correct oil level is maintained. Check every five hours
or daily before starting engine. See Checking Oil Level/Adding
Oil on page 5.
OIL CHANGE
WARNING
Before tipping engine or equipment to drain oil, drain
fuel from tank by running engine until fuel tank is
empty.
IMPORTANT: Be sure to check engine on a level surface with the
engine stopped. Drain the oil while the engine is still warm to
assure rapid and complete draining.
SERVICE AND MAINTENANCE
Each Use
First 5
or Every
Hours
5 Hrs.
WARNING
WARNING
Every
Every
Season or
Season or
25 Hours
50 Hours
2. Remove all fuel from tank by running engine until it stops
from lack of fuel.
3. Remove oil drain plug (a) and allow oil to drain into a suitable
container (Figure 8).
NOTE: Select engines are equipped with an oil drain located on
the rear of the engine.
a
10
Every
Service
Season or
Dates
100 Hours
Figure 8

Publicidad

loading