Publicidad
Idiomas disponibles
Idiomas disponibles
EN
Heating Tank
Important: Franke strongly recommends
using only genuine Franke components
in tandem with all Franke dispensing
faucets. The function of the dispensing
faucets cannot be guaranteed if using
filtration products, heating tanks, or
accessories other than genuine Franke
components.
Preliminary steps
1. It is recommended to take the
components and locate their
optimum positions before starting the
installation.
2. Make sure there is adequate clearance
for the dispenser handle(s) to open fully
without interference.
3. Make sure all plumbing and electrical
connections will reach the intended
mounting positions for all the
components and there will be no
obstruction or sharp bends in the
plumbing.
4. Make sure the counter top is no thicker
than 2".
Important: For subsequent steps, it will
be required to cut and route tubing to fit
the specific application in your home. All
tubing must be cut squarely and free of
burrs. Ensure there is no damage within 1"
of the cut end.
Do not use any forms of sealing
compounds: This is not required for
push fit connections, and using sealing
compounds could cause leaks.
Filtration Systems
All tubing connections must be routed to
avoid sharp bends and have enough slack
to avoid straining connections. Pull gently
on each connection to make sure they are
secure. See diagram below for details on
tubing installation and removal.
5. How to insert/remove tubing in push fit
connections:
– Insert the Tube (1) squarely (fig. 1A).
– Make sure to insert tubing completely
(fig. 1B).
1A
1
2
– To remove, push in Collet (2) and pull
out Tubing (1) (fig. 1C).
1C
5
6. Remove all contents from the package
and check for completeness.
7. Cut mounting hole 1-1/4" in diameter
(32 mm) in the desired position (if one
isn't available).
8. Turn off water supply.
6
Chiller Tank
1B
5
5
Publicidad
