Publicidad
Idiomas disponibles
Idiomas disponibles
CONTROL PANEL FEATURES
9
1. Engine Control Switch: Flip the switch to the "ON (l)"
position and pull the recoil starter to start the generator.
Turn to the "OFF (O)" position to turn off the generator.
2. Reset Switch: After the engine overload protection,
press the reset button to restore the output of the engine
without stopping the engine.
3. CO (Carbon Monoxide) WATCH-GUARD Indicator
Light (Red for Shut off and Yellow for Service): The CO
(Carbon Monoxide) WATCH-GUARD monitors for the
accumulation of poisonous CO gas around the genera-
tor produced by engine exhaust when the generator is
running. If the CO WATCH-GUARD detects increasing
levels of CO gas, it automatically shuts off the engine.
See CO WATCH-GUARD section for more information.
4. 5V DC USB Outlets: Supply 3.6A USB-A type and
3.0A USB-C type for different applications.
5. 120V AC, 20A Duplex, Single Phase, 60 Hz Outlets
(NEMA 5-20R):
Each outlet is capable of carrying a
maximum of 20 Amp on.
NOTE: Total power drawn from all outlets must not exceed the nameplate rating.
1
2
3
8
Page 09
4
7
6
6
6. Parallel Operation Outlets: These outlets are used
for connecting two AIPOWER inverter generators for
parallel operation. Do not connect or disconnect parallel
cables while the generator is running to avoid damage.
7. Ground Terminal: The ground terminal is used to
ground the generator.
8. Low Idle Switch: Low idle switch minimizes fuel
consumption and noise by adjusting the engine speed to
the minimum required for the current load.
9. Fuel Valve Knob: Used to open and close the fuel.
5
Publicidad
